Signal conditioners from Spectron are DC operated electronic modules which provide the proper AC excitation voltage for the mating tilt sensor, and a DC, 4-20mA or RS232 output signal. Available in both single and dual axis configurations, these signal conditioners are the perfect complement to our full line ofElectrolytic Tilt Sensors. Standard options include uni-polar/bi-polar DC operation, temperature and linearity compensation, and overload protection.

Temperature Compensation Resistor Selection Procedure, MUPI-3, SSY0079 and SA40012

Single Axis Signal Conditioners
	MUPI 2 Bi-polar input/output Overload protection Remote sensor/display capable Data Sheet

MUPI 3 Bi-polar input/output Temperature compensation option Overload protection Remote sensor/display capable Data Sheet Calibration Instructions

SA40012 Uni-polar input Low power consumption Temperature compensation option Overload protection Data Sheet

SA40072 Uni-polar input 4-20ma output Open architecture Data Sheet Calibration Instructions

SSY0079 Uni-polar input Bi-polar output Low power consumption Temperature compensation option Open architecture Data Sheet

SSY0135,Micro-50 Bi-polar input/output RS232 output Open architecture Data Sheet Operating Instructions

Dual Axis Signal Conditioners
	SA40011 Bi-polar input/output Temperature compensation option Overload protection Data Sheet

SA40015 Uni-polar input Temperature compensation option Overload protection Data Sheet

SA40111 Uni-polar input RS232 output On-board temperature and linearity compensation Data Sheet Communication Protocol Communication Software (5.06MB) Note: Do not run software unless board is attached